Tri mesh over 4 points

Mishal0488 <[email protected]>
Newsgroups gmane.comp.gnu.octave.general
Message-ID <[email protected]> 
Hi Guys

Referring to the attached image, I would like to develop a tri mesh enclosed
by 4 points which will be provided. Note that the points will vary and not
be standard points.

Is there any Octave function which can produce the required result?


Kind regards
Mishal Mohanlal 
<https://octave.1599824.n4.nabble.com/file/t373111/points.png> 



--
Sent from: https://octave.1599824.n4.nabble.com/Octave-General-f1599825.html
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.