Re: Frustrations/problems with GNU Prolog.
Fernando Sáenz Pérez <[email protected]>
| Newsgroups | gmane.comp.gnu.prolog.general |
|---|---|
| Message-ID | <[email protected]> |
Hello, >Finally, I'm wondering if there is any support for passing command line >arguments to executables implemented using GNU prolog? In an ideal world, >I'd pass the desired ranges as command line arguments rather than require >them to be entered interactively. Any hints gratefully received. > > Though it is intented to SWI-Prolog, you can also take a look to the following thread: http://comments.gmane.org/gmane.comp.ai.prolog.swi/14972 You might adat proposals there to your requirements. All the best, Fernando -- ============================================================== Fernando Saenz Perez Profesor Titular de Universidad / Associate Professor Home Page: http://www.fdi.ucm.es/profesor/fernan Tel: + 34 913947642. Fax: + 34 913947547 Despacho / Office: 435 (4ª planta / 4th floor) Dept. Ingenieria del Software e Inteligencia Artificial / Department of Software Engineering and Artificial Intelligence Universidad Complutense de Madrid Facultad de Informatica C/Profesor Jose Garcia Santesmases, s/n E - 28040 Madrid. Spain ==============================================================