Re: GNU Prolog 1.4.0 is released

This should not occurs...
Please try retsrat from scratch. Untar the source distribution.
Go to src/BipsPl
check file unify.wam exists (else this is an error, please tell me).
type
     touch unify.wam (to be sure it is more recent thant unify.pl).

then

./configure
make

Please keep me informed

Daniel


Le 09/11/2011 13:17, Nicolas Pelletier a écrit :
> Hello,
>
> On Wed, Jun 29, 2011 at 23:14, Daniel Diaz<[email protected]>  wrote:
>> gprolog 1.4.0 has just been released (see www.gprolog.org).
> Thank you for this new release of GNU Prolog.
>
> Today I tried building it on a sparc Solaris 10 machine, but failed:
> in BipsPl, while compiling unify.pl, gplc tries to run pl2wam, which
> is only compiled later (and needs the bips anyway). So it looks to me
> like I am missing one step in bootstrapping; the machine does not have
> gprolog installed before I try to compile. Here are the last few lines
> of output I get:
>
> gplc -c foreign.wam
> gplc -c pl_error.wam
> gplc -c utils.wam
> gplc -W --no-redef-error unify.pl
> error trying to execute pl2wam: No such file or directory
> compilation failed
> gmake[1]: *** [unify.wam] Error 1
> gmake[1]: Leaving directory `/home/nicolas/dev/gprolog-1.4.0/src/BipsPl'
> gmake: *** [all] Error 1
>
> Could you please advise on how to resolve this issue, please?
>
> Thank you in advance.
>


-- 
Ce message a ete verifie par MailScanner
pour des virus ou des polluriels et rien de
suspect n'a ete trouve.