Problems building gprolog 1.3.0 on Solaris 10
"Barnes, Kimberly-P27922" <[email protected]>
| Newsgroups | gmane.comp.gnu.prolog.general |
|---|---|
| Message-ID | <[email protected]> |
Make is failing with it complies the first .pl file. I have seen that others have had the same problem with different versions of gprolog but none of the solutions has worked for me and many did not have solutions. I really need help because my group is moving all our tools to Solaris 10 and I am holding up the move. Here is configuration information GNU Prolog version : 1.3.0 (Jan 4, 2007) Operating system : solaris2.10 Processor: sparc Size of Word: 32 bits C compiler: gcc (version 3.4.3) C flags: -DDEBUG C flags: machine : Loader Flags: Loader Libraries: -lm -lsocket -lns! Use line editor: Yes Use piped Consult: Yes Use Sockets: Yes Use FD solver: Yes Use Machine regs: Yes Used register(s): g6 g7 The following is the error that occurs during the make gplc -c --fast-math fd2c.pl .... trying at high addr: ffffff0 --> base: d75e000 length:10649600 obtaining: d75e000 +++Executing Obj Init Function at: bc1ac executing init obj of consult.wam compilation failed make[1] fd2c.0 [error 1] The following is the error that occurs when run pl2wam to get the debug information trying at high addr: ffffff0 --> base: d75e000 length:10649600 obtaining: d75e000 +++Executing Obj Init Function at: bc1ac executing init obj of consult.wam segmentation fault Thank you Kimberly Barnes Software Engineer Staff General Dynamics C4 Systems #R1216 8220 Roosevelt St Scottsdale, AZ 85254 Phone: 480-441-2290 Fax: 480-675-1449 "Tough Times Don't Last but Tough people Do" -Dr. Robert Schuller "This email message is for the sole use of the intended recipient(s) and may contain GDC4S confidential or privileged information. Any unauthorized review, use, disclosure or distribution is prohibited. If you are not an intended recipient, please contact the sender by reply email and destroy all copies of the original message."