Re: Scite and drgeo.

On Mon, 10 May 2004 14:11:04 -0500 (CDT)
Adrian Ulises Soto <adrianmatematico-/[email protected]> wrote:

  > Hi, Hilaire,
  >=20
  > How do I configure scite to work with drgeo and have
  > syntax highlight for scheme?

Piece of cake:

Name the DrGeo Scheme Figure with the  .scm extension, SCITE should
recognize it. It will give you syntax highlight

Also add a the end of  the /usr/share/scite/listp.properties file, the
following line (at the end):

command.go.$(file.patterns.scheme)=3D/usr/bin/drgeo -e $(FilePath)

Restart Scite (I guess it is needed). Then a DrGeo Scheme Figure edited
with SCITE can be evaluated in DrGeo by just pressing the F5 key or the GO
button.=20

IT REALLY HELP A LOT TO WRITE SCHEME FIGURE!


  > I am now on vacations, so I could work in some
  > translation of the manual.

Cool. I have not done that much in the French version of the DrGeo user
manual. Recently Andrea Centomo has done a lot of stuff in the Italian
version of the DrGeo user manual. It looks like the lead DrGeo user
manual is now the Italian version :-)

The French version should catch up on this Italian version aswell now.

Any VOLUNTEER to help on that?

Hilaire

--=20
Let's support Kids, Education and Free Software
Aidons les Enfants, l'=C9ducation et les Logiciels Libres
http://rate.affero.net/hilaire


-------------------------------------------------------
This SF.Net email is sponsored by Sleepycat Software
Learn developer strategies Cisco, Motorola, Ericsson & Lucent use to deliver
higher performing products faster, at low TCO.
http://www.sleepycat.com/telcomwpreg.php?From=osdnemail3