qt terminal behavior if no x11 is available
Dima Kogan <[email protected]>
| Newsgroups | gmane.comp.graphics.gnuplot.devel |
|---|---|
| Message-ID | <[email protected]> |
Hi. Is anybody here familiar with the qt terminal init sequence? I'm observing that if you try to plot anything without DISPLAY defined, the qt terminal throws an error and hangs. It does NOT give us the prompt back. This confuses tools that use gnuplot to make plots. There was a commit that changed the way this works: https://sourceforge.net/p/gnuplot/gnuplot-main/ci/c415285c230 Reverting that makes gnuplot give up after a few seconds. The x11 and wxt terminals figure it out immediately, but even a wait of several seconds is better than a forever hang we currently get. Is there a better way to handle errors in qt? Thanks! _______________________________________________ gnuplot-beta mailing list [email protected] Membership management via: https://lists.sourceforge.net/lists/listinfo/gnuplot-beta