Re: Recover parameter of the previous fit

On Monday, 27 May 2019 19:00:36 Patrick Dupre wrote:
> OK,
>  
> save fit 'save'
> should work,
>  
> How do I recover the parameters ?
> using via?
> I am not sure that I understand.

The inverse of "save" is "load"

	Ethan



>  
> Thank.
>  
> ===========================================================================
> Patrick DUPRÉ | | email: [email protected]
> Laboratoire interdisciplinaire Carnot de Bourgogne
> 9 Avenue Alain Savary, BP 47870, 21078 DIJON Cedex FRANCE
> Tel: +33 (0)380395988
> ===========================================================================
>  
>  
> Sent: Monday, May 27, 2019 at 6:39 PM
> From: "Ethan A Merritt" <[email protected]>
> To: [email protected]
> Cc: "Patrick Dupre" <[email protected]>
> Subject: Re: [Gnuplot-info] Recover parameter of the previous fit
> On Monday, 27 May 2019 16:53:59 Patrick Dupre wrote:
> > Hello,
> >
> > Sometimes, the fit does not converge properly and we would like to recover
> > the parameters of the previous fit.
> > 1) it is possible?
> > 2) if not, how can I save the parameters of a fit and recall them later?
>  
> Does the "save fit" command not work for you?
> The intended use is:
>  
> fit ... #works
> save fit 'save.file'
> ...
> ... lots of stuff that may or may not have worked
> ...
> load 'save.file' # restore saved variables.
>  
>  
> Ethan
>  
>  
> --
> entia non sunt multiplicanda praeter necessitatem
> 

-- 
entia non sunt multiplicanda praeter necessitatem

_______________________________________________
gnuplot-info mailing list
[email protected]
Membership management via: https://lists.sourceforge.net/lists/listinfo/gnuplot-info