Re: What signal to send to terminate gnuplot process?

Bottom line here: If you are using Windows then the UNIX signals 
mechanism is not available. msys2 may provide a UNIX-like shell, but 
ultimately it sits atop Windows. The fact that you cannot find a 
signals.h file is entirely predictable. There will not be one.

P.

On 06/02/2024 01:28, Mirko Vukovic wrote:
> Thanks for replying. My answers are below
>
> On Sun, Feb 4, 2024 at 10:20 AM Peter Rockett via gnuplot-info 
> <[email protected]> wrote:
>
>     Two questions:
>
>     1) Why do you want to send a SIGTERM to the process? Why isn't "exit"
>     (which you say works) good enough? The signal handler -- either the
>     default or an over-ridden version -- would typically invoke the
>     system
>     call that actually shuts down the process. Which is probably what the
>     gnuplot "exit" command does one way or another.
>
>
> You are correct that I really don't need to send SIGTERM. The reason 
> is my testsuite which is in 3 layers:
> 1. Lifecycle
> 2. IO streams
> 3. sending commands and reading results
>
> I wanted the first layer of the test suite (lifecycle) to be 
> independent of sending commands (last layer).
>
> I agree that this is somewhat of an overkill. But I was curious if it 
> could be done.
>
>     2) What OS are you using? Windows, for example, doesn't use signals -
>     they are a UNIX/Linux/MacOS(?) thing. I suspect sending a signal on
>     Windows will just be ignored, which is consistent with the
>     behaviour you
>     seem to be observing.
>
>
> I am on Windows 11 using gnuplot delivered via MSYS2. Since my 
> original post, I learned that I can use
> taskkill to terminate processes.
>
>
>     FWIW: The exact value of SIGTERM will be defined in a C header file
>     somewhere, probably "signals.h".
>
>
> I did not find that file, but I did not look terribly hard.
>
>
>     P.
>
>
> Thanks,
>
> Mirko
_______________________________________________
gnuplot-info mailing list
[email protected]
Membership management via: https://lists.sourceforge.net/lists/listinfo/gnuplot-info