Re: Drawing in H2 and S2 before finessing with Ipe

Thank you for an interesting piece of software.

I was successful in compiling the code on a Debian Wheezy system.
However, I find the following behaviour while trying to use the tool :
I need to press the pdf button for any changes I make to appear on the
screen. Is this intended? I find it difficult to use, since I am
unable to see what I am drawing in real time.

Best regards
Arvind Ajoy
www.arvindajoy.in

On 4/5/12, Sherif Ghali <[email protected]> wrote:
> Dear all,
>
> If in addition to drawing figures in the Euclidean plane you also
> sometime want to draw on the sphere or in the conformal model of the
> hyperbolic plane, you may be interested in gfDraw.
> http://www.dgp.toronto.edu/~ghali/software/gfdraw/index.html
>
> gfDraw lets you draw points, lines, segments, polygons, and Bézier
> curves, split polygons, and compute convex hulls and Delaunay
> triangulations in H2, E2, and S2.
>
> You can use gfDraw to generate the initial drawing in H2 or S2
> before finessing with Ipe:
> 1- Press the 'PDF' button to produce a PDF file.
> 2- Use 'pdftoipe' to generate the Ipe file.
> 3- Finish editing using Ipe.
>
> The main idea behind gfDraw is to develop geometric algorithms as only
> generic recipes. One then plugs in a geometry to produce concrete
> algorithms. gfDraw is currently supported on OS X and Qt 4.7.x-4.8.x.
>
> I hope you like it. Please send your feedback.
>
> Sherif
> _______________________________________________
> Ipe-discuss mailing list
> Ipe-discuss-rGrgPyRx506NN8uzcEdRPYRWq/[email protected]
> http://lists.science.uu.nl/mailman/listinfo/ipe-discuss
>