concentric circles with transparent centre
Alex Koudrin <[email protected]>
| Newsgroups | gmane.comp.graphics.ipe.general |
|---|---|
| Message-ID | <CADSnAxtY6GO3v3F_ipFUt5_s-ayikiAaoHT3zstbz1_PKvWGJg@mail.gmail.com> |
Hi Ipe users, I'd like to draw two concentric circles and I would like to have the inner-most circle to have no fill/be transparent representing a hole. The area between the inner and outer circle is filled with black. Think of a washer (as related to nut and bolt) then you have it right. At the moment, the only way I do this is by filling the inner circle with white and filling the outer circle with black. That's normally fine, but I have a case where I need to put the image on a coloured background with the expectation that you would see the background through the inner circle hole. Is there a way to do this in Ipe? Note that this is in latex through ps so opacity probably can't be used. Any suggestions appreciated! Alex _______________________________________________ Ipe-discuss mailing list Ipe-discuss-rGrgPyRx506NN8uzcEdRPYRWq/[email protected] http://lists.science.uu.nl/mailman/listinfo/ipe-discuss