Re: Millimeters grid units
André Lebacq <[email protected]>
| Newsgroups | gmane.comp.graphics.ipe.general |
|---|---|
| Message-ID | <[email protected]> |
On 28 May 2013, at 03:52, Otfried Cheong <[email protected]> wrote: > On 05/27/2013 06:39 PM, André Lebacq wrote: >> Ok. My concern, if I do this was about the font sizes. If I set a >> 10pt font size, to fit well with my document, the graphics letters >> will be resized by a 2.8 factor as well, no ? > > Yes, the text will be resized as well. But the factor 2.834646/3.0 is > about 95%, which will be not so visible. If you set the font size to > 11pt, it will be 10.4pt after resizing... Ok, thanks. Still a small question : what if I would like to run xelatex instead of pdflatex ? Is there a configuration parameter somewhere ? Thanks, André. -- André Lebacq