Re: ipe 7.2.13 doesn't read custom latex preamble?

Zhengdao Wang via Ipe-discuss wrote (Mon, Nov 25, 2019 at 06:23:37PM -0600):
> I spoke too fast. I am actually not sure what's the cause of the problem.
> Sorry.

As Otfried explained, the problem of text not showing up was because of embedded bitmap fonts. These were in turn caused by some error in my LaTeX setup, which automagically fixed itself.

So, problem solved. I'm sorry, I should probably have reported.

-mandar


> > -----Original Message-----
> > > From: Mandar Mitra via Ipe-discuss <ipe-discuss-rGrgPyRx506NN8uzcEdRPYRWq/[email protected]>
> > > Date: Wed, 13 Nov 2019 09:37:55 +0530
> > > To: ipe-discuss-rGrgPyRx506NN8uzcEdRPYRWq/[email protected]
> > > Subject: Re: [Ipe-discuss] ipe 7.2.13 doesn't read custom latex preamble?
> > > 
> > > Hi again,
> > > 
> > > I compiled 7.2.13 from source as instructed in install.txt. This solved the "macros.tex not found" problem.
> > > 
> > > But the problem shown in the attached screenshot still persists. Text shows up as boxes in the IPE interface, but the created PDF file looks fine.
> > > 
> > > Do I need to update / downgrade some other library?
> > > 
> > > Thanks,
> > > Mandar.
> > 
> > > _______________________________________________
> > > Ipe-discuss mailing list
> > > Ipe-discuss-rGrgPyRx506NN8uzcEdRPYRWq/[email protected]
> > > https://mailman.science.uu.nl/mailman/listinfo/ipe-discuss
> _______________________________________________
> Ipe-discuss mailing list
> Ipe-discuss-rGrgPyRx506NN8uzcEdRPYRWq/[email protected]
> https://mailman.science.uu.nl/mailman/listinfo/ipe-discuss