close an open path

Mark Barclay <[email protected]> Sat, 14 Mar 2009 14:35:40 -0400

Newsgroups	gmane.comp.graphics.omnigraffle.user
Message-ID	<C5E1713C.43C4%[email protected]>

I cannot seem to find a way to close an open path in OmniGraffle 5, such
that the start and end points become one and the object can be filled. Is
this supported by the editor?

Mark Barclay
Mishawaka, Indiana
[email protected]

lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.