Re: Connecting lines to lines.

If I understand your question correctly, I think you are looking for the line hops setting. That is in the Inspector. Look in the Line and Shapes area. There is a setting for line hops. There are several options to choose from there. 

Wayne


-----Original Message-----
>From: Michael Tiernan <[email protected]>
>Sent: Jun 2, 2010 1:40 PM
>To: OmniGraffle Users <[email protected]>
>Subject: Connecting lines to lines.
>
>I *know* I'm looking right at the solution to this but I can't find it.
>
>I'm attempting to make a network diagram.
>
>I have one line, the buss, going vertically (not that the direction 
>matters here), and smaller lines of the same make up that are going 
>horizontally between that buss and the systems.
>
>I'd like to make nice clean right angled connections so that when I 
>cross the two networks, they hop-over each other but the parts of one 
>network are attached and if I move something, the connection goes with it.
>
>Can anyone give me a pointer into the help docs for where I've got to 
>read to learn this?
>
>Thank you for everyone's time.
>