Any hints on how to start support for GL128-based Plustek Film Scanner OpticFilm 120?

Erik Beck of Tahoma <[email protected]> Sun, 29 Sep 2024 20:10:40 -0400

Newsgroups	gmane.comp.graphics.scanning.sane.devel
Organization	Tahoma
Message-ID	<[email protected]>

Hi,

I have an OpticFilm 120 and would like to support it; I've been using
Vuescan on Windows and that software has developed bad regressions,
which has increased my desire to try and write some Linux support for
it.

Any hints on how to start? It uses a GL128 chip from what I have
figured out so far, which is not currently supported by SANE.

Thanks,

Erik