PXA270 UDC driver from hh-CVS
Guennadi Liakhovetski <[email protected]>
| Newsgroups | gmane.comp.handhelds.general |
|---|---|
| Message-ID | <[email protected]> |
Hi I checked out the pxa27x_udc driver and the patches to ether.c from the hh CVS repository, applied them to 2.6.17 and I see that the control endpoint (0) works, but bulk endpoints (at least IN: 1) don't. I tried in DMA and PIO modes - same problem. Does it work for anybody? What might be the problem? I have an external OTG transceiver ISP1301 on this port, which I just configure statically, similarly I just configured the PXA's OTG registeres. I am not 100% sure the setup is correct, but since control ep works, bulks should do too? Thanks Guennadi --------------------------------- Guennadi Liakhovetski, Ph.D. DSA Daten- und Systemtechnik GmbH Pascalstr. 28 D-52076 Aachen Germany _______________________________________________ Open Source Software on Handheld Devices. Handhelds mailing list [email protected] https://handhelds.org/mailman/listinfo/handhelds irc://irc.openprojects.net #handhelds