Re: How do I make usb net?
Thomas Jensen <[email protected]>
| Newsgroups | gmane.comp.handhelds.linux.familiar |
|---|---|
| Message-ID | <1201804695.7040.28.camel@x21> |
Oh, I realize I have send the reply to Tomek only, and not the rest of the list. Here it is again, this time to the list, and with a few new questions. man, 28 01 2008 kl. 17:12 +0100, skrev Tomek Kontusz: > Thomas Jensen pisze: > > How/where can I see in Ubuntu if the pda is connected? If it is not, > > then what is most likely the problem? > > > $ lsusb Well, it shows no ipaq. I tried to load the wince-backup, and when I put the pda in the cradle and ran lsusb, it showed a line saying something about ipaq. So, the hardware is working, and Ubuntu is able to see ipaq. The problem is somehow the Familiar setup. In have followed the instructions in WindowsXpUsbNetworkHowTo, which I understand I need, before it will work with newer Linux kernels. But it still don't work. How can I verify if the g_ether module is loaded correct? Do I need to do more before lsusb on my Ubuntu PC will find the ipaq? I think when I get to the point where lsusb find the ipaq, I will be able to set up rest of the network. But I haven't been the yet. -- Thomas _______________________________________________ The Familiar Linux Distribution Familiar mailing list [email protected] https://handhelds.org/mailman/listinfo/familiar irc://irc.freenode.net #familiar