Re: How do I make usb net?

Hi Thomas,

it's nearly a year ago that I installed my usb net connection between HP2200 / 
Opie and kubuntu / Feisty thus my memory is not longer very accurate. I can 
give you only a shot into the dark:

On Montag, 4. Februar 2008, Thomas Jensen wrote:
> > 3. setup ip address and netmask of interfaces on iPAQ and PC,
> >    on IPAQ via GUI, on PC via
>
> Done.
>
> On iPAQ:
> IP address	192.168.0.202
> Subnet Mask	255.255.255.0
> Gateway		192.168.0.200
> and set to "Automatically bring up"
>
> On PC:
> iface usb0 inet static
> 	address 192.168.0.200
> 	netmask 255.255.255.0
> 	broadcast 192.168.0.255
>
> >    /etc/network/interfaces and "sudo ifup usb0"

Do you use a 2nd network on the same address, e.g. for eth0 something like 
192.168.0.1? This is not allowed. In my /etc/network/interfaces I've  defined

------------- snip -------------------------
auto eth0
iface eth0 inet static
address 192.168.0.2
netmask 255.255.0.0
gateway 192.168.0.1
------------------------------------------------
for eth0 and

------------- snip -------------------------
allow-hotplug usb0
iface usb0 inet static
address 192.168.1.2
netmask 255.255.0.0
broadcast 192.168.255.255
pre-up /etc/network/ipaq
-----------------------------------------------
for the usb network with /etc/network/ipaq containing:

------------- snip -------------------------
#!/bin/sh
sleep 5
exit 0
-----------------------------------------------

The two are in different sub-net domains.

Hope that helps
Gerhard

_______________________________________________
The Familiar Linux Distribution
Familiar mailing list
[email protected]
https://handhelds.org/mailman/listinfo/familiar
irc://irc.freenode.net #familiar