Re: Stopping LAB boot?

  Well, duh! I finally figured out -- well, not figured, but found
accidently -- that it's the keys on the keyboard of your serial terminal
on the desktop that you are supposed to press, not the buttons on the
ipaq. I was frantically pressing each and every button, and combinations
of buttons, to no avail.


Harmon Seaver wrote:
>    I want to reflash my h2200, but for some reason I can't get the boot
> to abort in LAB. I can reset and get the rescue bootloader prompt, but
> once linux starts booting, at the point where it says "press a key to
> abort the boot" it doesn't seem to matter which key I press, the boot
> continues. Is there a command I can give in the rescue bootloader to
> erase the flash? Not erase LAB, just the linux flash?
> 
> 


-- 
Harmon Seaver