Re: ipaq h5550

The H55xx series of Ipaq does not update the display when the bootloader
runs. It does buzz once when the bootloader starts.
It is accessible via the serial cable, and a program like Hyperterminal
can be used to access it as a serial console from Windows.
>From memory (and I have not done this in some years) you issue a 
	load root
command in the serial console and then send the root image via zmodem.
Once complete you issue a
	boot
command and root image should boot.

Hope this helps


On Tue, 2009-07-21 at 18:43 +0200, [email protected] wrote:
> Hello,
> i've successfully installed the bootloader in my ipaq h5550 then i
> press the joystick button and the reset button but when i do this it
> freezes and i have to remove the battery and press the reset button to
> switch it on again... what could i do?
> i don't understand also... which program should i use after this step
> with winXP? how can i send the image of opie or gpe to my device using
> that program? is that enough?
> 
> _______________________________________________
> The Familiar Linux Distribution
> Familiar mailing list
> [email protected]
> https://handhelds.org/mailman/listinfo/familiar
> irc://irc.freenode.net #familiar

_______________________________________________
The Familiar Linux Distribution
Familiar mailing list
[email protected]
https://handhelds.org/mailman/listinfo/familiar
irc://irc.freenode.net #familiar