RE: gcc installation failure on intimate build
"James Conner" <[email protected]>
| Newsgroups | gmane.comp.handhelds.linux.intimate |
|---|---|
| Message-ID | <[email protected]> |
Jim, The problem you are experiencing is because debian is often in a state of flux. The -all debian packages are built with x86 boxes, and often make it into the repositary many hours before the -arm packages. This tends to break all the dependencies for a few hours until the -arm packages catch up Chances are that if you try again today, it'll work. Good luck, Jim -----Original Message----- From: [email protected] [mailto:[email protected]]On Behalf Of Jim Binkley Sent: 21 December 2001 00:05 To: [email protected] Subject: [Intimate] gcc installation failure on intimate build I just built a new system with familiar 0.5, and put a microdrive on it, and did the intimate/reiser/install. gcc didn't install. E.g,. # apt-get install cpp gcc etc... fails (see below) I think the problem is that somehow versions 2.95-4.8 are being sought but they do not exist. The debian.org site has 4.9 versions. Can someone PLEASE tell me how to get cpp/gcc installed, as a favor. regards, Jim Binkley [email protected] example failure below: sloop:/usr/local/sbin# apt-get -f install Reading Package Lists... Done Building Dependency Tree... Done Correcting dependencies... Done The following extra packages will be installed: cpp gcc The following NEW packages will be installed: cpp gcc 0 packages upgraded, 2 newly installed, 0 to remove and 1 not upgraded. 2 packages not fully installed or removed. Need to get 6568B of archives. After unpacking 115kB will be used. Do you want to continue? [Y/n] y Err http://http.us.debian.org unstable/main cpp 2:2.95.4-8 404 Not Found [IP: 192.25.206.10 80] Err http://http.us.debian.org unstable/main gcc 2:2.95.4-8 404 Not Found [IP: 192.25.206.10 80] Failed to fetch http://http.us.debian.org/debian/pool/main/g/gcc-defaults/cpp_2.95.4-8_arm.d eb 404 Not Found [IP: 192.25.206.10 80] Failed to fetch http://http.us.debian.org/debian/pool/main/g/gcc-defaults/gcc_2.95.4-8_arm.d eb 404 Not Found [IP: 192.25.206.10 80] E: Unable to fetch some archives, maybe run apt-get update or try with --fix-missing? _______________________________________________ Intimate mailing list [email protected] http://handhelds.org/mailman/listinfo/intimate Received: from stanis.onastick.net (stanis.onastick.net [207.96.1.49]) by handhelds.org (8.9.3/8.9.3) with ESMTP id IAA25342 for <[email protected]>; Fri, 21 Dec 2001 08:12:01 -0800 Received: by stanis.onastick.net (Postfix, from userid 1009) id 1DC9B16B046; Fri, 21 Dec 2001 11:12:09 -0500 (EST) Date: Fri, 21 Dec 2001 11:12:08 -0500 From: Disconnect <[email protected]> To: James Conner <[email protected]> Cc: Chris Jones <[email protected]>, [email protected] Subject: Re: FW: [Intimate] dual sleeves in intimate? Message-ID: <[email protected]> References: <[email protected]> <[email protected]> Mime-Version: 1.0 Content-Type: text/plain; charset=us-ascii Content-Disposition: inline In-Reply-To: <[email protected]> User-Agent: Mutt/1.3.24i Sender: [email protected] Errors-To: [email protected] X-BeenThere: [email protected] X-Mailman-Version: 2.0beta2 Precedence: bulk List-Id: The intimate project - Full blown linux on the Compaq iPAQ <intimate.handhelds.org> On Wed, 19 Dec 2001, James Conner did have cause to say: > companion for my laptop, hooked up via USB). I don't think I've had a > filesystem on flash that will start X for over 6 months now.. I just use the > familiar bootstrap images... and that's pretty much it. If you're looking > for something ultra-lightweight to sit on flash, you could have a look at > Disconnect's Kiss distribution. The bootstrap was <2MB last time I looked, > so very quick to flash. Just an fyi.. you can play with the kiss bootstrap from kiss.handhelds.org/task-bootstrap-2.4.16.jffs2 (and .md5sum). The install-kiss stuff is in a massive state of flux, but the bootstrap is a very-basic system (no X etc) and boots intimate. The 2.4.16 kernel on there is home-grown, so you'll still have to copy the modules across to Intimate (or do the symlink stuff as Tangent indicated.) > Same here.. I made some images to start intimate from CE.. more to proove > that it could be done than anything. After that, I got rid of CE as quickly > as possible. Tangent - can you post info on that? I might get bored and want to update it (or at least try it) on pocketpc 2002.. --- -----BEGIN GEEK CODE BLOCK----- Version: 3.1 [www.ebb.org/ungeek] GIT/CC/CM/AT d--(-)@ s+:-- a-->? C++++$ ULBS*++++$ P- L+++>+++++ E--- W+++ N+@ o+>$ K? w--->+++++ O- M V-- PS+() PE Y+@ PGP++() t 5--- X-- R tv+@ b++++>$ DI++++ D++(+++) G++ e* h(-)* r++ y++ ------END GEEK CODE BLOCK------