Re: ttyS0 problem in kernel 2.6.17 and 2.6.20.

Henry von Tresckow <[email protected]>
Newsgroups gmane.comp.handhelds.openzaurus.devel
Message-ID <[email protected]>
Frederico,
I think the problem is actually somewhere in the power management code. 
I tried to build my own serial cable yesterday and while diagnosing it, 
I discovered that the 3.3V output on Pin 11 of the I/O connector was not 
working. I  just booted into the maintainance (OK+Cancel) screen, and 
the 3.3V works again. The reason for your serial problems is that the 
cable has internal components that are powered from this 3.3V output.

Federico Ruiz wrote:
> Hi list!
>
> I managed to get openzaurus-3.5.5 + kernel 2.6.20 running in my
> poodle. Everything I usually use is working (opie+ratoc CFU1.1 usb
> host controller + usb devices, and a lot of programs). But there is an
> exception: ttyS0 serial console. With kernel 2.4.18 I was using the
> serial console plus a particular cable
> (http://serialio.com/products/adaptors/ZThinCable.php) to connect the
> zaurus to a gps receiver (rs232). gpsd worked fine with that
> configuration. Even I was able to use minicom to get some strings out
> of the gps.
> Now in kernel 2.6.20 (or 2.6.17) I don't get anything from the serial
> port. There are no kernel errors or nothing. The problem is that I
> don't receive any data from the serial port.
>  I used minicom to try to comunicate to my gps. I configured all the
> serial port settings (hardware and software flow control off, baud
> rate, etc) in the right way.
>  I also play around with stty with no luck.
> If I flash back my zaurus to any openzaurus with kernel 2.4 the
> communication starts to work again.
> I think there is a connection with this problem in here:
> http://sourceforge.net/mailarchive/message.php?msg_id=45BCA447.7050502%40alumni.cse.cuhk.edu.hk
> but not sure.
> Is this a bug of the PXA serial driver in the kernel? (it looks like)
> Anybody else with the same problem?
> Any ideas what could be wrong?
>
> PS: I disabled the ttyS0 console connection in the inittab and then
> init q to reload the new configuration.
>
> Regards,
> Federico Ruiz.
>
> -------------------------------------------------------------------------
> Take Surveys. Earn Cash. Influence the Future of IT
> Join SourceForge.net's Techsay panel and you'll get the chance to share your
> opinions on IT & business topics through brief surveys-and earn cash
> http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV
> _______________________________________________
> Openzaurus-devel mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/openzaurus-devel
>
>   


-------------------------------------------------------------------------
Take Surveys. Earn Cash. Influence the Future of IT
Join SourceForge.net's Techsay panel and you'll get the chance to share your
opinions on IT & business topics through brief surveys-and earn cash
http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.