Re: Re: [Openzaurus-users] WiFi update for OZ 3.5.4

Hi,

I see you two have the same Wifi Card like me. Can you help me with a
problem I mentioned earlier in the user list?

I wanna know, what thos values in setting the txpower with "iwpriv
writemif 62 x" mean in dBm or some other usefull count. I write my
Diploma Thesis about MANETs and use Zauri to simulate a small one. And
for that I have to set the txpower to a very low level, to get
Multi-Hops within a small area.

I read in a forum, I can get some infos to calculate the dBm from that
numbers between 0...255 I can set with iwpriv. But where do I have to look?

Best regards,
Holger

Olivier Berger schrieb:
> Hi.
> 
> Is this still a possible problem with RC4 ?
> 
> I noticed that my DLink DCF 660W is now recognised as eth0 instead of
> wlan0 with RC4 (GPE image)...
> 
> I'm not sure I should investigate any further, as it seems to be
> working more or less like that...
> 
> Thanks in advance.
> 
> Best regards,
> 
> Marcin Juszkiewicz <[email protected]> writes:
> 
>> Hi
>>
>> I prepared update of hostap-conf/orinoco-conf for OpenZaurus 3.5.4. Please 
>> update and report any card which was wlan0 and now is eth0 to OE 
>> bugtracker: http://bugs.openembedded.org/show_bug.cgi?id=836
>>
>> If someone has a card which stopped working after this update then please 
>> report too.
>>
>> Those who use OZ 3.5.4.1-alpha/rc on clamshells does not need this 
>> update - I will release rc2 during next few days with this fixes (2.6 
>> kernels has driver mapping inside of kernel).
>>
> 


-------------------------------------------------------
Using Tomcat but need to do more? Need to support web services, security?
Get stuff done quickly with pre-integrated technology to make your job easier
Download IBM WebSphere Application Server v.1.0.1 based on Apache Geronimo
http://sel.as-us.falkag.net/sel?cmd=lnk&kid=120709&bid=263057&dat=121642