Re: strange USB Problem

On Thursday 10 January 2008 22:14, Michael Renner wrote:
> Moin,

Moin,

just for the archive: I  bought me a 2nd USB card (PCI) and now the zaurus 
works via USB:

kernel: ohci_hcd 0000:02:07.0: wakeup
kernel: usb 6-2: new full speed USB device using ohci_hcd and address 14
kernel: usb 6-2: configuration #1 chosen from 1 choice
kernel: usbcore: registered new driver cdc_ether
kernel: usb0: register 'zaurus' at usb-0000:02:07.0-2, Sharp Zaurus SL-5x00, 
62:ad:0a:05:5e:69
kernel: usbcore: registered new driver zaurus

But there is an other problem: USB connection only works as long as the 5 V 
power supply is not (!) connected to the craddle! If it is connected the 
connection fails:

kernel: ohci_hcd 0000:02:07.0: wakeup
kernel: hub 6-0:1.0: Cannot enable port 2.  Maybe the USB cable is bad?

Any hint?
Thanks!
-- 
|Michael Renner      E-mail: [email protected]  |
|D-81541 Munich      Germany        ICQ: #112280325 |
|Germany             Don't drink as root!      ESC:wq

-------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace