Re: How to get pen pressure under Opie?
Michael 'Mickey' Lauer <[email protected]>
| Newsgroups | gmane.comp.handhelds.opie.devel |
|---|---|
| Organization | Institute of Computer Science, University of Frankfurt |
| Message-ID | <[email protected]> |
> On some panels, depending on the nature of the inconsistencies, you can > make it useful. For example, using the tsc2103 controller and a panel > on the device I was working on at TI in E&PS, I was able to write a > linear calibration (thankfully it was linear) for its pressure values. > I'd like to see a new tslib handle this a bit better, via a more > extensible, modular calibration piece. Sorry for hijacking this thread, but while we're at it, would it be possible to add a "reload" call to tslib to make it reload the calibration data? Atm. after performing a calibration you need to close tslib and reopen it to make it use the calibration data - this can be cumbersome at times. -- Regards, Mickey. ------------------------------------------------------------------ Dipl.-Inf. Michael 'Mickey' Lauer <[email protected]> ------------------------------------------------------------------ _______________________________________________ http://opie.handhelds.org/cgi-bin/moin.cgi/DeveloperWikiIndex Opie-devel mailing list [email protected] https://handhelds.org/mailman/listinfo/opie-devel