Re: Can I not have both: opie and X

On Saturday 24 March 2007 06:43, you wrote:
> > Paul and Kai,
> >
> > I have put xqt at the following location. It will stay there for a few
> > weeks:
> >
> > http://www.kiatoa.com/oe/xqt_0.0.9-r0_arm.ipk
> >
> > This is compiled for the h2200. If that doesn't work for you let me
> > know and I'll compile for the H3850.
> >
> > Matt
>
> Thank you verry much! It runs on my H3850!! Means the X-server starts, I
> see the cross and the gray background. And now? If I changed to another
> app in opie i.e. opie-console to start a X app I come not back to the x
> server. If I tri it I get the message "XQt is not responding..." How can
> I work withe x server?

Kai

I really havent' done much with it. I did try a couple apps, xdemineur and 
rxvt seem to work but I can't type into the rxvt terminal. xkbd starts but 
you can't see the keys and so on. I think that there is quite a bit of 
configuration to be done for it to work well. Perhaps installing the gpe 
base stuff would get it to work. I have the same problem and can't switch 
back and forth with Opie.

To get anything done I simply worked with it via ssh over the usb net.

Good luck!

Matt
--

> Thanks a lot!
>
> Kai
>
> What can I do to compile the XQt-server? And are ther some depenxies i.e.
> must I install the xlibs, xfonts and so on?

-- 
http://www.kiatoa.com, fight for a better world.
_______________________________________________
Open Source User Interface and Apps built on Qt Embedded
Opie mailing list
[email protected]
https://handhelds.org/mailman/listinfo/opie