Re: T3 problem (off topic but appreciate some help)

Hi 
The reason why you get the messages on start it is because the new settings are store and loaded every time.

Do a  "warm reset" hold the Up button while resetting.(check to find how it is done on T3)

What I would tried first is to run the program and change the old settings then restart it again.
If this does not work, "warm reset" and with resco explorer remove either the Fitaly settings or the entire program.


--- In [email protected], "geoffl54" <portsmouth@...> wrote:
>
> I have a Palm T3 and I'm sticking to it for as long as it lasts (I've got a spare). But it has crashed with the following error message:
> 
> "Fatal Alert
> Bitmap.c,Line:1082,BMPGetDensity: invalid argument"
> 
> I was experimenting with the settings of Fitaly and this happened. If I tap the <Reset> button, it restarts but comes back to this message.
> 
> I decided to bite the bullet and do a hard start but that does not owrk. I cannot turn the T3 off with its power button either.
> 
> Any suggestions would be very much appreciated. If I can get it basically operational again, I can rebuild it as I Hotsynced it yesterday.
> 
> Thanks
> Geoff
>