Re: Is opensimpad closed source?

Hi Till,

OpenSIMpad was built from OpenZaurus. All sources can be obtained there 
using Bitkeeper and CVS. See the following Link for Information about 
working with that.
http://opensimpad.org/wiki/index.php/Docs/BuildingCustomImages

As mentioned in this page the OpenZaurus Buildroot there is no longer 
mantained since everything is being transitioned to OpenEmbedded. When 
that is accomplished then OpenSIMpad will continue on this basis.

If you are only interessted in Kernel stuff then the CVS stuff at sf.net 
should have everything you need. I can't remember that we added any 
changes in Buildroot that differ from those at sf.net.

Regards,
Chris Martin

Till Harbaum wrote:

>Hi Walter,
>
>On Thursday 02 September 2004 18:32, Schweizer Walter wrote:
>  
>
>>Opensimpad has a special build system that I have never tried.
>>    
>>
>So what you describe in your howto is _not_ the way to work with opensimpad? 
>Is there any documentation on the opensimpad build system? www.opensimpad.org 
>does not mention any build system.
>
>  
>
>>Basically you need to check out the sources from bitkeeper and CVS servers.
>>The images you mention are from opensimpad.
>>    
>>
>They are the same ones as on sourceforge.
>
>In the meantime i have found a jpm2 patch (there are plenty of them in 
>bitkeeper, dunno which one does what, they all patch the kernel to 
>-rmk7-jpm2) by copy and paste from some bitkeeper web frontend.
>
>I was able to compile the btuart_cs kernel module and it loads fine into the 
>kernel (it doesn't work, but that may be a problem with the xircom cards 
>bitrate).
>
>Ciao,
>  Till
>
>  
>


-------------------------------------------------------
This SF.Net email is sponsored by BEA Weblogic Workshop
FREE Java Enterprise J2EE developer tools!
Get your free copy of BEA WebLogic Workshop 8.1 today.
http://ads.osdn.com/?ad_id=5047&alloc_id=10808&op=click