Re: [Simpad-general] /proc/sys/board patch for SIMpad

Till Harbaum <[email protected]> Fri, 17 Sep 2004 11:33:38 +0200

Newsgroups	gmane.comp.handhelds.openembedded,gmane.comp.handhelds.simpad.linux
Organization	BeeCon GmbH
Message-ID	<[email protected]>

Hi,

On Thursday 16 September 2004 20:03, freesurf wrote:
> the simpad has got only one led which can set from software. The other
> led is hardware controlled and indicate the state of power charging
It's the green led that can be software controlled.

If you write a 0 to /proc/sys/board/led2_on, the leds is switched of for a few 
msec, but the kernel immediately switches it on again. You can see the led 
flicker for a very short time.

Ciao,
  Till

-- 
Dr.-Ing. Till Harbaum                       Tel.:  +49 721 4998963
BeeCon GmbH                                 Fax:   +49 721 4998962
Haid-und-Neu Strasse 7, 76131 Karlsruhe     Mobil: +49 179 9087904
[email protected]                           http://www.beecon.de