RE: FW: Bootldr is available for Simpad

Hi Jose

You can download the Flash bootldr with serial port only.
Protocol is Ymodem usually.
PCMCIA Ethernet is not supported in Bootldr.

Regards
Walter

> -----Original Message-----
> From: Jose Bernardo Silva [mailto:[email protected]]
> Sent: Saturday, September 25, 2004 8:10 PM
> To: Schweizer Walter; [email protected]
> Subject: RE: FW: [Simpad-general] Bootldr is available for Simpad
> 
> 
> On Tue, 14 Sep 2004 12:41:58 +0200, Schweizer Walter wrote
> > Hi Jose
> > 
> > Bootldr runs with 115k baud.
> > Switch your terminal emulator to 115k.
> 
> Walter,
> I now have bootloader on the simpad ram, but... I can't seem 
> to get it to
> flash ("load bootldr" tries to download it again using 
> xmodem?) and I can't
> find how to use the ne2k pcmcia adapter to download images as 
> I do with the
> siemens boot loader.
> What am I doing wrong? Can you help me here?
> 
> ---
> Jose Bernardo B R Silva             | Source Mage GNU/Linux 
> Section Guru
> [email protected]            | http://www.sourcemage.org
> http://counter.li.org #245602
> http://cosmos.oninetspeed.pt/jose.bernardo
> [email protected]
> 
> 


-------------------------------------------------------
This SF.Net email is sponsored by: YOU BE THE JUDGE. Be one of 170
Project Admins to receive an Apple iPod Mini FREE for your judgement on
who ports your project to Linux PPC the best. Sponsored by IBM.
Deadline: Sept. 24. Go here: http://sf.net/ppc_contest.php