Re: AVR-GCC-list Digest, Vol 97, Issue 2
[email protected] (Joerg Wunsch)
| Newsgroups | gmane.comp.hardware.avr.gcc |
|---|---|
| Organization | Private BSD site, Dresden |
| Message-ID | <[email protected]> |
Gerrit Bosch <[email protected]> wrote: > Last question, can VTG be set only from AVR Studio, not with Avrdude > or something else running on a Mac? VTG can also be set through AVRDUDE, but only from "terminal mode" (option -t). As the startup will probe for a valid AVR ISP connection, if you don't have a target connected to ISP (or if your VTG is set to 0 for some reason so the target cannot respond), you have to force it entering terminal mode by -F. Once in terminal mode, use something like vtarg 3 You should also be able to read out the current settings by parms If there's enough demand, it would perhaps also be possible to add a commandline option for it (through the -x "extended options" feature), but so far, nobody seemed to care much about it. -- cheers, J"org .-.-. --... ...-- -.. . DL8DTL http://www.sax.de/~joerg/ NIC: JW11-RIPE Never trust an operating system you don't have sources for. ;-)