Re: AVR-GCC-list Digest, Vol 97, Issue 4

> If there's enough demand, it would perhaps also be possible to add a
> commandline option for it (through the -x "extended options" feature),
> but so far, nobody seemed to care much about it.

It would be exiting for me to do this, but may be I am not the best for the job. Where to start? Savannah?

Beste groeten, Gerrit.



Op 11 feb. 2013 om 18:00 heeft [email protected] het volgende geschreven:

> Send AVR-GCC-list mailing list submissions to
>    [email protected]
> 
> To subscribe or unsubscribe via the World Wide Web, visit
>    https://lists.nongnu.org/mailman/listinfo/avr-gcc-list
> or, via email, send a message with subject or body 'help' to
>    [email protected]
> 
> You can reach the person managing the list at
>    [email protected]
> 
> When replying, please edit your Subject line so it is more specific
> than "Re: Contents of AVR-GCC-list digest..."
> 
> 
> Today's Topics:
> 
>   1. Re: AVR-GCC-list Digest, Vol 97, Issue 2 (Joerg Wunsch)
> 
> 
> ----------------------------------------------------------------------
> 
> Message: 1
> Date: Mon, 11 Feb 2013 09:19:08 +0100 (MET)
> From: [email protected] (Joerg Wunsch)
> To: [email protected]
> Subject: Re: [avr-gcc-list] AVR-GCC-list Digest, Vol 97, Issue 2
> Message-ID: <[email protected]>
> Content-Type: text/plain; charset=us-ascii
> 
> Gerrit Bosch <[email protected]> wrote:
> 
>> Last question, can VTG be set only from AVR Studio, not with Avrdude
>> or something else running on a Mac?
> 
> VTG can also be set through AVRDUDE, but only from "terminal mode"
> (option -t).  As the startup will probe for a valid AVR ISP
> connection, if you don't have a target connected to ISP (or if your
> VTG is set to 0 for some reason so the target cannot respond), you
> have to force it entering terminal mode by -F.
> 
> Once in terminal mode, use something like
> 
> vtarg 3
> 
> You should also be able to read out the current settings by
> 
> parms
> 
> If there's enough demand, it would perhaps also be possible to add a
> commandline option for it (through the -x "extended options" feature),
> but so far, nobody seemed to care much about it.
> -- 
> cheers, J"org               .-.-.   --... ...--   -.. .  DL8DTL
> 
> http://www.sax.de/~joerg/                        NIC: JW11-RIPE
> Never trust an operating system you don't have sources for. ;-)
> 
> 
> 
> ------------------------------
> 
> _______________________________________________
> AVR-GCC-list mailing list
> [email protected]
> https://lists.nongnu.org/mailman/listinfo/avr-gcc-list
> 
> 
> End of AVR-GCC-list Digest, Vol 97, Issue 4
> *******************************************
>