Re: different behavior on port A and port C
[email protected] (Joerg Wunsch)
| Newsgroups | gmane.comp.hardware.avr.gcc |
|---|---|
| Organization | Private BSD site, Dresden |
| Message-ID | <[email protected]> |
dfx <[email protected]> wrote: > The same program, on port C generates the square wave only on pins 0, 1, > 6, 7 while the others remain fixed. The other pins are assigned to JTAG by default. Either turn off the JTAG fuse (but then, you could not use JTAG for programming anymore either), or dynamically disable it at run-time with the JTD bit. (Please subscribe to the list to not miss replies.) -- cheers, Joerg .-.-. --... ...-- -.. . DL8DTL http://www.sax.de/~joerg/ Never trust an operating system you don't have sources for. ;-)