Re: Converting string to uint32_t

Georg-Johann Lay <[email protected]> Tue, 14 Oct 2014 11:23:48 +0200

Newsgroups	gmane.comp.hardware.avr.gcc
Message-ID	<[email protected]>

Am 10/13/2014 11:57 PM, schrieb Andreas Höschler:
> Hi all,
>
> doing my first cautious steps in C on an Arduino I try to convert a string read over the serial interface to a uint32_t.

So what's wrong with strtoul from stdlib.h ?

>
> [snipped bulk op code]
>

Johann

p.s.

You started this new thread as an answer to "Building code", presumably of 
laziness.  This means your mail is filed deep inside the "Building code" thread 
and hence is likely to be overlooked when someone is not deeply involved in 
that thread.  Better start a new thread at top level, i.e. not as an answer to 
any other mail.


_______________________________________________
AVR-GCC-list mailing list
[email protected]
https://lists.nongnu.org/mailman/listinfo/avr-gcc-list