Re: Re: CAN Mask & Filter setting at ---- software level

>> This is the result created by every CAN controller ... it's simply not
my equation!

!( filtr ^ a_ ) | mask;    ----------------- or ------------------>>>>  !(
( filtr ^ a_ ) | mask );
two time you changed the enclosing  brackets ... which one .. ?


!( ( filtr ^ a_ ) | mask );  ----->> this is failing i tested many times
I do not know why it is not working if it is standard equation ....... when
i put break point and test under debugger ... ???
But mine is working & passing required ID ....  tried many times ....even
you can just try at your end ... not even take 10 minutes..

Dont know .. ?

On Fri, Dec 7, 2012 at 7:13 PM, Steinhoff <[email protected]> wrote:

> This is the result created by every CAN controller ... it's simply not my
> equation!