Re: Re: CAN Mask & Filter setting at ---- software level

Dinesh Guleria wrote:
> >> This is the result created by every CAN controller ... it's simply 
> not my equation!
>
> !( filtr ^ a_ ) | mask;    ----------------- or ------------------>>>> 
> !( ( filtr ^ a_ ) | mask );
> two time you changed the enclosing  brackets ... which one .. ?

!( ( filtr ^ a_ ) | mask );==>  !( filtr ^ a_ ) & !mask; ==> not equal 
!(( filtr ^ a_ ) | mask

>
>
> !( ( filtr ^ a_ ) | mask );----->> this is failing i tested many times
> I do not know why it is not working if it is standard equation ....... 
> when i put break point and test under debugger ... ???
> But mine is working & passing required ID ....  tried many times 
> ....even you can just try at your end ... not even take 10 minutes..
>
> Dont know .. ?
>
> On Fri, Dec 7, 2012 at 7:13 PM, Steinhoff <[email protected] 
> <mailto:[email protected]>> wrote:
>
>     This is the result created by every CAN controller ... it's simply
>     not my equation!
>
>