Re: CANstress configuration
canlist_NOT via NavTool <[email protected]>
| Newsgroups | gmane.comp.hardware.bus.can |
|---|---|
| Message-ID | <[email protected]> |
Am Freitag 26 Juli 2013, 06:30:31 schrieb canlist_NOT via What is going on here? Does the List Server have problems? -- mit freundlichen Grüßen Heinz-Jürgen Oertel -- Archives and useful http://groups.yahoo.com/group/CANbus [http://groups.yahoo.com/group/CANbus] Subscribe and unsubscribe at www.vector.com/canlist/ [http://www.vector.com/canlist/] Report any problems to <[email protected] [[email protected]]> On Jul 26, 2013 at 6:30 a.m. canlist_NOT <[email protected] [[email protected]]> > Am Freitag 26 Juli 2013, 11:19:19 schrieben To get into error passive is very simple even without devices like CANstress. Let the CAN controller send a frame and remove all other nodes from the CAN bus. If the transmitting not does not get any acknowledge from other nodes, it will increase the transmit error counter until it reaches the error passive state. -- mit freundlichen Grüßen Heinz-Jürgen Oertel