Re: CAN bit timing
Dinesh Guleria <[email protected]>
| Newsgroups | gmane.comp.hardware.bus.can |
|---|---|
| Message-ID | <CAKpDV8tCeU8FuKQXTQMeWV+4bG4tGOnXx3-VqgJWtbxj022T4A@mail.gmail.com> |
I just went through datasheet of i.MX 6Solo. Yes it will work with i.MX 6Solo controller from freescale.. because it suports FlexCAN. On Tue, Aug 27, 2013 at 4:46 PM, Dinesh Guleria <[email protected]>wrote: > Just one more thing is :-- > Clock Rate in MHz, *from 1 to 300*. Use the value of the clock rate at > the first stage of the BaudRatePrescaler BTR, not the clock of the > controller or crystal (typically for a 16 MHz clocked NXP SJA1000 use '8'). > > What exactly we mean by the above statement for clock rate? Does it the > final clock obtained after applying baudrate prescaler & number of time > quanta for one bit. > As shown iin attached picture. > > > On Tue, Aug 27, 2013 at 4:23 PM, Dinesh Guleria <[email protected]>wrote: > >> Wow .. that great one ... & very simple to use than using some of the >> calculators i have used previously. >> Does it applicable for Freescale I-Max 6 solo controllers also ? >> >> Drop down list only mention about Frescale Flexcan & TouCAN. >> >> Please suggest. >> >> Regards, >> Dinesh >> >> >> On Tue, Aug 27, 2013 at 12:48 AM, Heinz-Jürgen Oertel < >> [email protected]> wrote: >> >>> I have added Infineon MultiCAN >>> http://www.bittiming.can-wiki.info/#Infineon >>> Please test. >>> -- >>> mit freundlichen Grüßen >>> Heinz-Jürgen Oertel >> >> >> >