AW: can4linux for the BananaPi
Sueltrop Christian <[email protected]>
| Newsgroups | gmane.comp.hardware.bus.can |
|---|---|
| Message-ID | <[email protected]> |
Hello again, I re-checked the info in the BananaPi wiki and think I got it. Due to multiplexing, the signal name differs from the A20 user manual. Sorry for the inconvenience, Christian -----Ursprüngliche Nachricht----- Von: [email protected] [mailto:[email protected]] Im Auftrag von Sueltrop Christian Gesendet: Dienstag, 19. August 2014 10:04 An: CANLIST Betreff: AW: [CANLIST] can4linux for the BananaPi Hello Heinz-Jürgen, has can4linux been tested with an actual BananaPi? If I understand the hardware docs in the BananaPi Wiki (http://wiki.bananapi.org/index.php/Main_Page) correctly, the CAN signals CAN-TX and CAN-RX (Port A 16 and 17, according to the port configuration table in the A20 user manual) are not routed to the GPIO connector. Is there another way to connect a CAN transceiver to CAN-TX and CAN-RX? Does anyone know another (inexpensive) single board linux computer with on-chip CAN? Best regards, Christian -- Dipl.-Ing. Christian Sültrop Universität Erlangen-Nürnberg Lehrstuhl für Elektronische Bauelemente Cauerstraße 6, 91058 Erlangen, Germany [email protected] http://www.leb.eei.uni-erlangen.de +49 (0)9131 761-121 -- Archives and useful links: http://groups.yahoo.com/group/CANbus Subscribe and unsubscribe at www.vector.com/canlist/ Report any problems to <[email protected]> -- Archives and useful links: http://groups.yahoo.com/group/CANbus Subscribe and unsubscribe at www.vector.com/canlist/ Report any problems to <[email protected]>