AW: can4linux for the BananaPi
"Uwe Wilhelm \(GMX\)" <[email protected]>
| Newsgroups | gmane.comp.hardware.bus.can |
|---|---|
| Message-ID | <[email protected]> |
PEAK offer 2 boards: GridARM Linux Board BSP Version with CAN (1x Socket CAN - the Standard for LINUX) Ethernet Gateway BSP Version (2x CAN Socket CAN - the Standard for LINUX) Regards Uwe > -----Ursprüngliche Nachricht----- > Von: [email protected] [mailto:canlist- > [email protected]] Im Auftrag von Sueltrop Christian > Gesendet: Dienstag, 19. August 2014 10:17 > An: CANLIST > Betreff: AW: [CANLIST] can4linux for the BananaPi > > Hello again, > > I re-checked the info in the BananaPi wiki and think I got it. Due to > multiplexing, the signal name differs from the A20 user manual. > > Sorry for the inconvenience, > Christian > > -----Ursprüngliche Nachricht----- > Von: [email protected] [mailto:canlist- > [email protected]] Im Auftrag von Sueltrop Christian > Gesendet: Dienstag, 19. August 2014 10:04 > An: CANLIST > Betreff: AW: [CANLIST] can4linux for the BananaPi > > Hello Heinz-Jürgen, > > has can4linux been tested with an actual BananaPi? > > If I understand the hardware docs in the BananaPi Wiki > (http://wiki.bananapi.org/index.php/Main_Page) correctly, the CAN signals > CAN-TX and CAN-RX (Port A 16 and 17, according to the port configuration > table in the A20 user manual) are not routed to the GPIO connector. Is there > another way to connect a CAN transceiver to CAN-TX and CAN-RX? > > Does anyone know another (inexpensive) single board linux computer with > on-chip CAN? > > Best regards, > Christian > > -- > Dipl.-Ing. Christian Sültrop > > Universität Erlangen-Nürnberg > Lehrstuhl für Elektronische Bauelemente > > Cauerstraße 6, 91058 Erlangen, Germany > > [email protected] > http://www.leb.eei.uni-erlangen.de > +49 (0)9131 761-121 > > > > -- > Archives and useful links: http://groups.yahoo.com/group/CANbus > Subscribe and unsubscribe at www.vector.com/canlist/ > Report any problems to <[email protected]> > -- > Archives and useful links: http://groups.yahoo.com/group/CANbus > Subscribe and unsubscribe at www.vector.com/canlist/ > Report any problems to <[email protected]> -- Archives and useful links: http://groups.yahoo.com/group/CANbus Subscribe and unsubscribe at www.vector.com/canlist/ Report any problems to <[email protected]>