Re: Distance between end nodes in a Car
Heinz-Jürgen Oertel <[email protected]>
| Newsgroups | gmane.comp.hardware.bus.can |
|---|---|
| Organization | privat |
| Message-ID | <1912072.kKLSithiuX@heinz> |
Am Sonntag, 7. Dezember 2014, 10:22:54 schrieb Dinesh Guleria:
> Just want to set the propagation time segment on an average in an CAR
Some controllers have register for setting the propagation delay, some have not.
For me it is always important to set the sample point location, whether or not I have to use a propagation delay register or not.
One rule I try to follow is setting all nodes to use the same sample point and the same number of time quanta for a bit.
--
mit freundlichen Grüßen
Heinz-Jürgen Oertel
--
Archives and useful links: http://groups.yahoo.com/group/CANbus
Subscribe and unsubscribe at www.vector.com/canlist/
Report any problems to <[email protected]>