Re: future of the CAN FD protocol
Heinz-Jürgen Oertel <[email protected]>
| Newsgroups | gmane.comp.hardware.bus.can |
|---|---|
| Organization | privat |
| Message-ID | <5144724.LVybRhChT9@heinz> |
Am Dienstag, 9. Dezember 2014, 18:23:53 schrieb Heinz-Jürgen Oertel:
>
> Read more about current development on the way to an ISO standard
> http://www.can-newsletter.org/engineering/standardization/141209_iso-can-fd-or-non-iso-can-fd/
And the latest optimistic outlook on industrial use:
Holger Zeltwanger wrotes in Embedded networking
"The CANopen SIG application layer is preparing the CiA 301 version 5.0. The updated CANopen application layer will support CAN FD. This means 64-byte PDOs are possible. This application layer and communication profile will be named CANopen FD. It is expected that the version 5.0 will be released in spring 2015."
I think we did a good work in the SIG application layer. You will see products at the next "Embedded World" end of Februyry 2015.
--
mit freundlichen Grüßen
Heinz-Jürgen Oertel
emtas GmbH
--
Archives and useful links: http://groups.yahoo.com/group/CANbus
Subscribe and unsubscribe at www.vector.com/canlist/
Report any problems to <[email protected]>