RE: Loop connection

 Hideki,
 
First of all, I've changed the subject title; it's not considered polite to hijack other people's threads.
 
To your question as to why CAN "is not Specify Loop Type connection", bear in mind that CAN is a broadcast network, not a point-to-point network.  As such, it is somewhat akin to a radio: a node "broadcasts" it's data but doesn't know how many other nodes are listening; it may be 1 or it could be 100.  If some number of those nodes go off-line or become disconnected, the broadcasting node neither knows nor cares.  The only requirement is that there must be at least 1 other node active to acknowledge the transmission.
 
Regards,
Al Pothoof
From: [email protected]
To: [email protected]; [email protected]
Subject: RE: [CANLIST] Busmaster CAN bus simulator -- "Function editor"
Date: Mon, 30 Mar 2015 08:44:10 +0000









Hello
 
I have a question  about CAN Netowork.
CAN Network is not Specify Loop Type connection.
 
I want to know why .
I  consider Redundant system of CAN Network.

If the system detect cutting CAN wire, the system connect another CAN wire.

 
Its system problem is ability of loop connection.
 
Kind Regurds,
 
hideki MASUDAYA