Re: CANBus bitrate calculating
J Nagy <[email protected]> Fri, 1 May 2015 17:08:32 -0400
| Newsgroups | gmane.comp.hardware.bus.can |
|---|---|
| Message-ID | <[email protected]> |
If you use a scope to see the smallest bit time in a message, you can determine baud rate. For example, if you measure 2 usec, that would be 500 kbaud. Jim > On May 1, 2015, at 3:36 PM, Anry A. Kischka <[email protected]> wrote: > > Hi there! > If i not know the bitrate of CAN bus line, standard speeds (like 10, 20, > 125 etc.) tried, but I haven't received any messages. I long time ago > readed on some forum that calculate bitrate with help of oscilloscope. > Isn't it? > Can help me anybody? > > > -- > With best regards, Anry. > > -- > Archives and useful links: http://groups.yahoo.com/group/CANbus > Subscribe and unsubscribe at www.vector.com/canlist/ > Report any problems to <[email protected]> -- Archives and useful links: http://groups.yahoo.com/group/CANbus Subscribe and unsubscribe at www.vector.com/canlist/ Report any problems to <[email protected]>