RE: Can my node identify the Busoff, if my node does not transmit any frames?

"John Dammeyer" <[email protected]> Tue, 22 Mar 2016 09:09:41 -0700

Newsgroups	gmane.comp.hardware.bus.can
Message-ID	<[email protected]>

On most devices the nodes will not go bus off but only error passive when receiving incorrect messages.  They only go bus off when their transmitted message fails 32 times.  That’s to prevent a babbling idiot scenario where a node continuously transmits because of a failure.
 
Perhaps tell us a couple of things:
1.       What processor/CAN device?
2.       What CAN bus driver?
3.       Do you have another node on the network like a CAN bus monitor and if so what brand?
4.       Is this a school class assignment?
John Dammeyer
 
 
From: [email protected] [mailto:[email protected]] On Behalf Of Boopathi Raja
Sent: March-22-16 8:33 AM
To: [email protected]
Subject: [CANLIST] Can my node identify the Busoff, if my node does not transmit any frames?
 
Hi All,
 
Can anybody explain me, When my node identify the busoff, if i do not transmit any frame?
 


Best Regards
--------------------
G.BoopathiRaja