RE: CAN bit timing, Seg2 =1Tq

That puts the sample point at the 87.5% point and is really on the edge.  You haven’t described how long a bus you want to create or what type of cable you want to use.  All that will affect how long a bus you can make at that bit rate.
John Dammeyer
 
 
From: [email protected] [mailto:[email protected]] On Behalf Of Amitai Broyde
Sent: July-15-16 12:30 AM
To: [email protected]
Subject: [CANLIST] CAN bit timing, Seg2 =1Tq
 
Hi,
I am using 1Mbps CAN network based on Cores running at 8MHz. I would like to extend the bus length by setting sampling point 125ns before end of bit time. Current bit sampling time is 250ns before end of bit time. 
Will it work?
 
Regards,
ab