Re: SPC5 from STM

Hi,

its kind of an off-topic question for this list.

Anyway, I'd like to share some thoughts.
We are working with an SPC570S which does not support CAN FD yet. Anyway, I=
 assume the compilers will be the same. We use Green Hills Compiler (GHS) a=
nd it the ST's examples compiled with the  gcc included in SPC5Studio as we=
ll.=20
When using a different compiler getting  a fitting board-support-package or=
 initialization code might be a bit challenging.

Best Regards
  Torsten Gedenk



Hi list,
does anyone use a SPC5 32-bit Automative MCUs for CAN FD from STMicroelectr=
onics ?
What type of C compiler you use ?
Thanks.

RF design engineer

Gediminas Simanskis
www.rusoku.com





=2D------------------------------------------------------------------------
emtas GmbH
=46ritz-Haber-Stra=DFe 9
06217 Merseburg
Germany
Tel.:  +49 3461 79416-18
=46ax.:  +49 3461 79416-10
www.emtas.de - [email protected]
Gesch=E4ftsf=FChrer: Andreas Boebel, Torsten Gedenk, Steffen Rose
Registergericht: Amtsgericht Stendal
Registernummer:  HRB 17616=20
=2D------------------------------------------------------------------------

--
Archives and useful links: http://groups.yahoo.com/group/CANbus
Subscribe and unsubscribe at www.vector.com/canlist/
Report any problems to <[email protected]>