simulating an error frame in canoe using capl

hi all,

i am learning canoe,i created two nodes and wrote a capl programme to send
messages each other periodically.
could you please guide me how to simulate error frame in can bus there by
error counters to be modified in the simulation.
i used a capl function output(error frame); but it doesn't effect the error
counters.
i didnt used any real nodes.
could you please let me know is this analysis is correct?

please guide me on it.

thanks in advance.

sunil kumar reddy



--
Sent from: http://can-bus.996267.n3.nabble.com/
--
Archives and useful links: http://groups.yahoo.com/group/CANbus
Subscribe and unsubscribe at www.vector.com/canlist/
Report any problems to <[email protected]>