RE: bridge mode

Salim Şişman <[email protected]>
Newsgroups gmane.comp.hardware.cisco.turkish
Message-ID <[email protected]>
 
Merhabalar,
 
Merkez için şu konfigürasyonu kullanabilirsiniz, Uç(Şube) noktada BVI falan yaratmanıza gerek yok sadece ATM subinterface'i altına atm route-bridged ip parametresini girmeyi unutmayın bu kısım onemli.
 
Merkez :
 
bridge irbbridge 1 protocol ieeebridge 1 route ip!interface Serial1/1:3.1bridge-group 1frame-relay map bridge 43 broadcast!interface BVI1 ip address 192.168.20.37 255.255.255.252
 
 
Sube :
 
interface ATM0               mtu 1500          no ip address               no atm ilmi-keepalive                       dsl operating-mode auto                         cdp enable           ! interface ATM0.1 point-to-point                                ip address 192.168.20.38 255.255.255.252                                        no snmp trap link-status                          atm route-bridged ip            pvc 0/35           protocol ip 192.168.20.37 broadcast                                     encapsulation aal5snap                        !
ip classless
! 
ip route 0.0.0.0 0.0.0.0 192.168.20.37
no ip http server
 
 
 
 
Salim SismanNetwork / Data & Voice Specialist
 
 
> To: [email protected]> From: [email protected]> Date: Wed, 24 Sep 2008 11:22:33 +0300> Subject: [cisco-ttl] bridge mode> > > Aþaðýdaki þekilde bridge mode da hat çalýþmýyor . sebebi ne olabilir . TT bridge mode çalýþmasý gerek diyor. Bu hat mpls backbone nundan geçiyormuþ TT de..> > Þube;> > interface ATM0/0.1 point-to-point 
bandwidth 512 
bridge-group 1 
pvc 0/35 
vbr-nrt 512 512 
encapsulation aal5snap
!
! 
interface FastEthernet0/0 
 ip address 10.xx.xxx.1 255.255.255.0 
 speed auto
!
!
interface BVI1 
ip address 192.168.20.38 255.255.255.252
!
ip classless
 
ip route 0.0.0.0 0.0.0.0 192.168.20.37
no ip http server
!
bridge 1 protocol 
ieeebridge 1 route ip> > > > > merkez ( kanallý e1 in içinde 512 fr de 512 gshdsl sonlanýyor. )> > interface Serial1/1:3 
no ip address encapsulation 
frame-relay IETF frame-relay 
lmi-type ansi
!
interface Serial1/1:3.1 point-to-point 
description ** **512gshdsl 
bandwidth 512 
delay 10 
frame-relay interface-dlci 43 
http://www.live.com/getstarted.aspx

[Non-text portions of this message have been removed]


------------------------------------

--
Cisco Teknik Tartisma Listesi (Cisco-ttl)

Bu listede onerilen degisikliklerin uygulanmasindaki tum sorumluluk 
kullaniciya aittir. Liste yoneticileri, oneride bulunan liste uyeleri ya da 
bu uyelerin calistigi kuruluslar herhangi bir sekilde sorumlu tutulamazlar.Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/cisco-ttl/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/cisco-ttl/join
    (Yahoo! ID required)

<*> To change settings via email:
    mailto:[email protected] 
    mailto:[email protected]

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.