RE: L2 Problemi

Merhaba,
Cisco Error Message Decoder yasadigin sorun icin asagidakileri soyluyor;

1.
		%C4K_L2MAN-6-INVALIDSOURCEADDRESSPACKET:
		Packet received with invalid source MAC address ( [mac-addr]  ) on port [char]   in vlan  [dec]
		A packet was received with an all zero or a multicast source address. The packet is 
treated as invalid and no learning is done. Excessive flow of such packets can waste CPU cycles. 
This message is rate-limited and is displayed only for the first such packet received on any interface 
or VLAN. Subsequent messages will display cumulative count of all such packets received in given 
interval on all interfaces.


		Recommended Action:
Check the switch configuration file to find the source of these packets on the 
specified port and take corrective action to fix them at the source end. You can also enable port 
security on that interface to shutdown the port if the incoming rate of packets with invalid source 
mac address is too high by issuing the switchport port-security limit rate invalid-source-mac 
 command.

		
			
		
Related documents- No specific documents apply to this error message.
		

Bu arada bilgi acisindan aldigin hata ile ilgili http://www.cisco.com/cgi-bin/Support/Errordecoder/index.cgi adresine girip % ile baslayan hata mesajini submit ettiginde hatanin neden kaynaklandigini soyluyor.

selamlar

Ozgur


--- On Sun, 11/9/08, Onur Cepheli <[email protected]> wrote:
From: Onur Cepheli <[email protected]>
Subject: RE: [cisco-ttl] L2 Problemi
To: [email protected]
Date: Sunday, November 9, 2008, 11:04 AM

Merhabalar,

Verdi»iniz linki t¹klad¹»¹mda

An Error occured with the submited URL-state request.

Hatas¹ almaktay¹m..


Karº¹ uca eriºimim yok. Gi1/1 uplink portum. Trunk olarak çal¹ºmakta.

Aºa»¹ya show int ç¹kt¹s¹ ekliyorum.

UZEM-4500-1#show int gi1/1
GigabitEthernet1/1 is up, line protocol is up (connected)
  Hardware is Gigabit Ethernet Port, address is 000e.3838.8e00 (bia
000e.3838.8e00)
  MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec, 
     reliability 255/255, txload 2/255, rxload 1/255
  Encapsulation ARPA, loopback not set
  Keepalive set (10 sec)
  Full-duplex, 1000Mb/s, link type is auto, media type is 1000BaseSX
  input flow-control is on, output flow-control is off
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input 00:00:00, output never, output hang never
  Last clearing of "show interface" counters never
  Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: fifo
  Output queue: 0/40 (size/max)
  5 minute input rate 280000 bits/sec, 234 packets/sec
  5 minute output rate 9819000 bits/sec, 912 packets/sec
     186821829 packets input, 37514759370 bytes, 0 no buffer
     Received 79577170 broadcasts (33891744 multicast)
     0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
     0 input packets with dribble condition detected
     200311408 packets output, 252281996207 bytes, 0 underruns
     0 output errors, 0 collisions, 0 interface resets
     0 babbles, 0 late collision, 0 deferred
     0 lost carrier, 0 no carrier
     0 output buffer failures, 0 output buffers swapped out


      

[Non-text portions of this message have been removed]


------------------------------------

--
Cisco Teknik Tartisma Listesi (Cisco-ttl)

Bu listede onerilen degisikliklerin uygulanmasindaki tum sorumluluk 
kullaniciya aittir. Liste yoneticileri, oneride bulunan liste uyeleri ya da 
bu uyelerin calistigi kuruluslar herhangi bir sekilde sorumlu tutulamazlar.Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/cisco-ttl/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/cisco-ttl/join
    (Yahoo! ID required)

<*> To change settings via email:
    mailto:[email protected] 
    mailto:[email protected]

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/